I used one of those thin stencils for scrapbooking, I centered it and taped it into place~
Then I spread a layer of the joint compound over the cut out area I wanted to appear on my mailbox door. I would say it was about 2/16" thick~
Once the compound had set up for a few minutes, I just peeled off the tape and carefully lifted the stencil up and off revealing the design~
Here it is painted.... I distressed it using some brown paint. I am not sure I am going to keep it like this due to the fact that the tile this is going to be set into is stark white and this might just end up looking "dirty".....so its going to sit up against the tile for awhile until I decide :-).jpg)
You can find more show & tells over at Kelli's blog.
